Paradyne Hotwire 8300 Instrukcja Użytkownika

1Hotwire® 8300 EndpointInstallation InstructionsDocument Number 8300-A2-GN10-00April 2003ContentsProduct Documentation Online ...

10UNITED STATES – EMI NOTICE:This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of t

11The Telephone Company may make changes in its facilities, equipment, operations or procedures that could affect the operation of the equipment. If

12 Important Safety Instructions 1. Read and follow all warning notices and instructions marked on the product or included in the manual.2. This produ

1310. This unit is provided with a replaceable lithium battery. Replace the battery only with the same type recommended by the manufacturer. Discard u

14Document FeedbackWe welcome your comments and suggestions about this document. Please mail them to Technical Publications, Paradyne Corporation, 854

15

16*8300-A2-GN10-00**8300-A2-GN10-00*

2Package ChecklistVerify that your package contains the following:❑ 8300 Endpoint❑ Power cord❑ 8-pin modular cable for connection to the DSL network❑

3Installing the Power CordThe POWER port on the unit is a standard, grounded, three-prong connector. The unit has no power switch. Figure 1.

4Front Panel LEDs and SwitchesThe front panel’s LED status indicators are described below: The user-activated input control buttons are described belo

5Connecting the Supervisory PortThe SUPERVISORY port is a DB9 female DCE connector configured for 8 bits, no parity, and 1 stop bit. Bit rates are con

6Connecting the Ethernet PortThe unit provides a single Ethernet interface port for IP Gateway, SNMP, and Web browser access. This interface is an eig

7Connecting the CBR PortThe CBR (Constant Bit Rate) port is an RJ48C, eight-pin modular jack that is software-selectable for T1 or E1. As a T1 port, i

8Web InterfaceIf you will use the Ethernet port for the web interface, you must set the IP address of the port, or use the default address of 192.168.

9Accessing the Web InterfaceTo access the web interface:Procedure1. Start your web browser. Microsoft Internet Explorer version 5.0 or higher is recom